Some CPAPs Are $300 Off This Weekend! Log In to See Details
<

Fisher & Paykel myAirvo 2 Oxygen Inlet Kit

Model: 900PT422
$44.99$59.99SAVE $15.00
In Stock
Email Me When Available

1x myAirvo 2 Oxygen Inlet Kit

Fisher & Paykel myAirvo 2 Oxygen Inlet Kit

The myAirvo2 Oxygen Inlet Kit is required to connect supplementary oxygen to the Airvo 2/myAirvo 2 Humidified High Flow System

Note: Oxygen must only be added through the oxygen inlet port on the back of the myAirvo2 unit. To ensure that oxygen enters the unit correctly, the oxygen inlet port must be fitted properly to the filter holder and the filter holder must be fitted properly to the unit. The power cord connector should also be well-secured.

Do not connect more than 60 L/min oxygen to the oxygen inlet port.

Installation Instructions

  1. Ensure that the power cord connector is well secured to the rear of the unit- if necessary, secure with a cable tie.
  2. Clean and dry the side of the unit.
  3. Push the end of the tubing  0.3 inches (1 cm) onto the filter holder.
  4. Remove the adhesive label and firmly attach the oxygen inlet port to the myAirvo 2 unit.
  5. Wait 24 hours before use to allow the adhesive to set.

For detailed instructions, please refer to your myAirvo2 User Manual. 

General
Model900PT422
HCPCS CodeE1399
ManufacturerFisher & Paykel

Questions? Ask here. We typically respond within 12-24 hours, often sooner. You'll receive email notifications once answered.

Share your review with our customers and earn $2.00 worth of points!